[ Pobierz całość w formacie PDF ]

ÿþSPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
PETROL X
BMW Serie 6 04 ’! DIESEL
’!
MAKE MOD. YEAR
ALARM/SIREN Position the compact alarms and the sirens on the support of the shock absorber, driver s
side.
POSITION
CENTRAL UNIT POSITION
Position the modular sistems and the modules under the dashboard, driver s side.
POWER SUPPLY +30: connect to the big wire located on the  POSITIVE climp directly in the battery.
-31: connect to the big wire located on the  NEGATIVE climp marked directly in the battery, in
the boot.
IGNITION WIRE +15/54: connect to the VIOLET/WHITE wire, at the position nr.4, in the wiring harness coming
out of the 41 way black connector, of the white central located on the left of the steering
column, under the driver s side dashboard.
DIRECTION INDICATORS System with separated lines
Connect to the wires: BLUE/YELLOW at the pos. nr.22, VIOLET/BLACK at the pos. nr.39,
BLUE/GREEN at the pos. nr.68, BLUE/BROWN at the pos. nr.61 and BLUE/BROWN with
YELLOW references at the pos. nr.4, BLUE/GREY at the pos. nr.11 located in the 76 way
white connection of the black central placed on the left of the steering column, under the
driver s side dashboard. Separate the lines with 1N5406 diodes.
ELECTRIC WINDOWS Comfort closing
The windows closing is obtained using the original remote control.
CENTRAL DOORS LOCKING Negative control signal
Connect with both the OPEN and CLOSE wires of the antitheft to the YELLOW/RED wire at
the position nr.28, from the 41 way black connector, in the white central located on the left of
the steering column, under the driver s side dashboard.
IMMOBILISATION POINT Fuel pump
Cut the WHITE/BLUE or VIOLET/BLACK wire in the wiring harness coming out of the relé of
the fuel pump located behind the glove compartment, passenger s side.
STARTER +50: Cut the 2 mm2 BLACK wire at the position nr.22, in the 41 way black connector, of the
white central located on the left of the steering column, under the driver s side steering column.
BONNET SWITCH Install an additional switch on the headlamps support plate, driver s side.
DOORS SWITCH Connect to the BLUE/RED wire at the pos. nr.54, of the 54 way black connector, of the black
central behind the glove compartment, driver s side.
BOOT SWITCH Connect to the WHITE/BROWN wire in the connector of the boot lamp.
HORN CONTROL Positive control
Connect to the VIOLET/GREY wire in the wiring harness on the side of the steering column,
under the driver s side dash board.
As alternative, the same wire is located in the taping wiring harness, behind the passenger s
side glove compartment.
Note: It is suggested to cut the wire with the NO, NC and COM contacts of the Cobra Connex.
bmse604gbb.doc
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual. [ Pobierz całość w formacie PDF ]